Cisco Cisco Meraki MS390-48U
- The Cisco Meraki MS390-48U is a cloud-managed switch designed for high-density, high-speed networks.
Specifications
- PoE
- 802.3bt/802.3at/802.3af
- QoS
- Yes
- USB
- Yes
- Cloud Management
- Yes
- Layer
- L3
- Ports
- 48x 1G RJ-45
- VLANs
- 4094
- Uplinks
- 4x 10G SFP+
- PoE Ports
- 48
- Switching Capacity
- 176 Gbps
- Management
- Meraki Dashboard
- PoE Budget
- 740 W
Potential Threats
18 Known CVEs
Default IP
192.168.1.1
Default admin panel address for Cisco Cisco Meraki MS390-48U
Known CVE Vulnerabilities (18)
A vulnerability in the VPN and management web servers of the Cisco Adaptive Security Virtual Appliance (ASAv) and Cisco Secure Firewall Threat Defense...
A vulnerability in the file policy feature that is used to inspect encrypted archive files of Cisco Firepower Threat Defense (FTD) Software could allo...
A vulnerability in the web-based management interface of Cisco Integrated Management Controller (IMC) could allow an authenticated, remote attacker wi...
A vulnerability in the CLI of the Cisco Integrated Management Controller (IMC) could allow an authenticated, local attacker to perform command injecti...
A vulnerability in the IKEv1 fragmentation code of Cisco IOS Software and Cisco IOS XE Software could allow an unauthenticated, remote attacker to cau...
A vulnerability in the IPv4 Software-Defined Access (SD-Access) fabric edge node feature of Cisco IOS XE Software could allow an unauthenticated, remo...
A vulnerability in the DHCP version 4 (DHCPv4) server feature of Cisco IOS XR Software could allow an unauthenticated, remote attacker to trigger a cr...
A vulnerability in the Secure Copy Protocol (SCP) and SFTP feature of Cisco IOS XR Software could allow an authenticated, local attacker to create or...
A vulnerability in the VirusEvent feature of ClamAV could allow a local attacker to inject arbitrary commands with the privileges of the application s...
A vulnerability in the access control list (ACL) programming for port channel subinterfaces of Cisco Nexus 3000 and 9000 Series Switches in standalone...
Showing 10 of 18
FAQ
The most common default credentials for Cisco Cisco Meraki MS390-48U are listed in the table above. Always change these immediately after setup.
The default username for Cisco Cisco Meraki MS390-48U is typically "admin". The full list of default credentials including username, password, access type and port is shown in the table on this page.
Log in to the admin panel using the default credentials listed above. Navigate to Administration → Password or System → Account settings. Enter the current password and set a new strong password. Save the changes.
Locate the Reset button (usually a small pinhole on the back/bottom of the device). Hold it for 10-30 seconds while powered on until the LEDs flash. The device will reboot with default settings.
No. Default credentials are publicly known and frequently exploited by automated scanners. Change the admin password immediately after first login.
Cisco Cisco Meraki MS390-48U has 18 known CVE vulnerabilities documented in our database. The full list with severity ratings is shown on this page. Apply the latest firmware update from the manufacturer to address known issues.
