Cisco Cisco Catalyst 2960-48TT-L
- The Cisco Catalyst 2960-48TT-L is a fixed-configuration, Gigabit Ethernet switch that provides reliable and secure access to network resources.
Specifications
- OS
- Cisco IOS
- LAN
- Fast Ethernet
- QoS
- Yes
- RAM
- 64 MB
- Flash
- 32 MB
- Layer
- Layer 2
- Ports
- 48x 10/100 + 2x 10/100/1000
- VLANs
- 255
- Uplinks
- 2x Gigabit RJ-45
- Auto MDI/X
- Yes
- LAN Ports
- 48x 10/100
- Switching Capacity
- 16 Gbps
- Management
- CLI, SNMP, Web
Potential Threats
Default IP
192.168.0.1
Default admin panel address for Cisco Cisco Catalyst 2960-48TT-L
Default Credentials — Cisco Cisco Catalyst 2960-48TT-L
| Username | Password | Access Type | Protocol | Port | Notes |
|---|---|---|---|---|---|
| (blank) | (blank) | console | Console | — |
FAQ
The most common default credentials for Cisco Cisco Catalyst 2960-48TT-L are listed in the table above. Always change these immediately after setup.
The default username for Cisco Cisco Catalyst 2960-48TT-L is typically "admin". The full list of default credentials including username, password, access type and port is shown in the table on this page.
Log in to the admin panel using the default credentials listed above. Navigate to Administration → Password or System → Account settings. Enter the current password and set a new strong password. Save the changes.
Locate the Reset button (usually a small pinhole on the back/bottom of the device). Hold it for 10-30 seconds while powered on until the LEDs flash. The device will reboot with default settings.
No. Default credentials are publicly known and frequently exploited by automated scanners. Change the admin password immediately after first login.
No CVE vulnerabilities have been linked to Cisco Cisco Catalyst 2960-48TT-L in our database. This may mean the device has a good security record, or that vulnerabilities exist but have not been officially assigned CVE identifiers.
