Cisco Catalyst 2960

WS-C2960-24TT-L - Cisco Catalyst 2960 Series Switches are fixed-configuration, standalone switches.

Specifications

RAM: 64 MB
Flash: 32 MB
Layer: Layer 2
Ports: 24x 10/100 + 2x SFP

Potential Threats

No known vulnerabilities found for this device.

Disable all unused ports. Enable port security and 802.1X authentication. Use separate VLANs for management traffic.

FAQ

What is the default password for Cisco Catalyst 2960?

The most common default credentials for Cisco Catalyst 2960 are listed in the table above. Always change these immediately after setup.

What is the default username for Cisco Catalyst 2960?

The default username for Cisco Catalyst 2960 is typically "admin". The full list of default credentials including username, password, access type and port is shown in the table on this page.

How do I change the password on Cisco Catalyst 2960?

Log in to the admin panel using the default credentials listed above. Navigate to Administration → Password or System → Account settings. Enter the current password and set a new strong password. Save the changes.

How do I reset Cisco Catalyst 2960 to factory defaults?

Locate the Reset button (usually a small pinhole on the back/bottom of the device). Hold it for 10-30 seconds while powered on until the LEDs flash. The device will reboot with default settings.

Is it safe to leave default credentials unchanged?

No. Default credentials are publicly known and frequently exploited by automated scanners. Change the admin password immediately after first login.

Does Cisco Catalyst 2960 have known security vulnerabilities?

No CVE vulnerabilities have been linked to Cisco Catalyst 2960 in our database. This may mean the device has a good security record, or that vulnerabilities exist but have not been officially assigned CVE identifiers.