Cisco Cisco Meraki MS390-24
- The Cisco Meraki MS390-24 is a cloud-managed, 24-port Gigabit Ethernet switch designed for high-density environments.
Specifications
- OS
- Cisco IOS XE
- PoE
- Yes
- QoS
- Yes
- USB
- Yes
- Cloud Management
- Yes
- Layer
- Layer 3
- Ports
- 24x 1G RJ-45
- VLANs
- 4094
- Uplinks
- 4x 10G SFP+
- LAN Ports
- 24x 1G RJ-45
- PoE Ports
- 24
- Switching Capacity
- 128 Gbps
- Management
- Meraki Dashboard
- PoE Budget
- 370 W
Potential Threats
25 Known CVEs
Default IP
192.168.1.150
Default admin panel address for Cisco Cisco Meraki MS390-24
Known CVE Vulnerabilities (25)
Multiple Cisco products are affected by a vulnerability in the rate filtering feature of the Snort detection engine that could allow an unauthenticate...
A vulnerability in the session authentication functionality of the Remote Access SSL VPN feature of Cisco Adaptive Security Appliance (ASA) Software a...
A vulnerability in the Snort 2 and Snort 3 TCP and UDP detection engine of Cisco Firepower Threat Defense (FTD) Software for Cisco Firepower 2100 Seri...
A vulnerability in the SSH subsystem of Cisco Adaptive Security Appliance (ASA) Software could allow an authenticated, remote attacker to execute oper...
A vulnerability in the handling of specific Ethernet frames by Cisco IOS XR Software for various Cisco Network Convergence System (NCS) platforms coul...
A vulnerability in Cisco Intelligent Node (iNode) Software could allow an unauthenticated, remote attacker to hijack the TLS connection between Cisco...
A vulnerability in the ConfD CLI and the Cisco Crosswork Network Services Orchestrator CLI could allow an authenticated, low-privileged, local attack...
A vulnerability in the management and VPN web servers for Cisco Adaptive Security Appliance (ASA) Software and Cisco Firepower Threat Defense (FTD) So...
A vulnerability in the web-based management interface of Cisco TelePresence Management Suite (TMS) could allow a low-privileged, remote attacker to co...
A vulnerability in the web-based management interface of Cisco Identity Services Engine (ISE) could allow an authenticated, remote attacker to conduct...
Showing 10 of 25
FAQ
The most common default credentials for Cisco Cisco Meraki MS390-24 are listed in the table above. Always change these immediately after setup.
The default username for Cisco Cisco Meraki MS390-24 is typically "admin". The full list of default credentials including username, password, access type and port is shown in the table on this page.
Log in to the admin panel using the default credentials listed above. Navigate to Administration → Password or System → Account settings. Enter the current password and set a new strong password. Save the changes.
Locate the Reset button (usually a small pinhole on the back/bottom of the device). Hold it for 10-30 seconds while powered on until the LEDs flash. The device will reboot with default settings.
No. Default credentials are publicly known and frequently exploited by automated scanners. Change the admin password immediately after first login.
Cisco Cisco Meraki MS390-24 has 25 known CVE vulnerabilities documented in our database. The full list with severity ratings is shown on this page. Apply the latest firmware update from the manufacturer to address known issues.
