Cisco Cisco Catalyst 9600-40YC
- The Cisco Catalyst 9600-40YC is a high-performance, scalable switch designed for data center and campus networks.
Specifications
- OS
- Cisco IOS XE
- QoS
- Yes
- USB
- Yes
- Layer
- Layer 3
- Ports
- 40x 25G SFP28, 8x 100G QSFP28
- VLANs
- 4094
- Uplinks
- 8x 100G QSFP28
- LAN Ports
- 48
- Max VLANs
- 4094
- Switching Capacity
- 6.4 Tbps
- Management
- Console, USB, Ethernet
- Operating Temp
- 32 to 104°F
Potential Threats
25 Known CVEs
Default IP
192.168.1.123
Default admin panel address for Cisco Cisco Catalyst 9600-40YC
Known CVE Vulnerabilities (25)
Improper input validation in some UEFI firmware SMM module for the Intel(R) reference platforms may allow an escalation of privilege. System software...
Rejected reason: This CVE ID has been rejected or withdrawn by its CVE Numbering Authority because it is Unused
Rejected reason: This CVE ID has been rejected or withdrawn by its CVE Numbering Authority because it is Unused
Uncontrolled search path in some software installer for some VTune(TM) Profiler software and Intel(R) oneAPI Base Toolkits before version 2025.0. with...
Improper Isolation or Compartmentalization in the stream cache mechanism for some Intel(R) Processors may allow an authenticated user to potentially e...
A vulnerability in Cisco Unified Intelligence Center could allow an authenticated, remote attacker to elevate privileges to Administrator for a limite...
A vulnerability in multiple Cisco Unified Communications and Contact Center Solutions products could allow an authenticated, local attacker to elevate...
Uncontrolled search path element for some Intel(R) Network Adapter Driver installers for Windows 11 before version 29.4 may allow an authenticated use...
A vulnerability in confederation implementation for the Border Gateway Protocol (BGP) in Cisco IOS XR Software could allow an unauthenticated, re...
A vulnerability in the web UI of Cisco APIC could allow an authenticated, remote attacker to perform a stored XSS attack on an affected system. To exp...
Showing 10 of 25
FAQ
The most common default credentials for Cisco Cisco Catalyst 9600-40YC are listed in the table above. Always change these immediately after setup.
The default username for Cisco Cisco Catalyst 9600-40YC is typically "admin". The full list of default credentials including username, password, access type and port is shown in the table on this page.
Log in to the admin panel using the default credentials listed above. Navigate to Administration → Password or System → Account settings. Enter the current password and set a new strong password. Save the changes.
Locate the Reset button (usually a small pinhole on the back/bottom of the device). Hold it for 10-30 seconds while powered on until the LEDs flash. The device will reboot with default settings.
No. Default credentials are publicly known and frequently exploited by automated scanners. Change the admin password immediately after first login.
Cisco Cisco Catalyst 9600-40YC has 25 known CVE vulnerabilities documented in our database. The full list with severity ratings is shown on this page. Apply the latest firmware update from the manufacturer to address known issues.
