Cisco Cisco Catalyst 9500-24Y4C
- The Cisco Catalyst 9500-24Y4C is a high-performance, scalable switch designed for data center and campus networks.
Specifications
- OS
- Cisco IOS XE
- USB
- Yes
- Layer
- Layer 3
- Ports
- 24x 1/10/25G SFP28, 4x 40/100G QSFP28
- VLANs
- 4094
- Uplinks
- 4x 40/100G QSFP28
- LAN Ports
- 24
- Max VLANs
- 4094
- Switching Capacity
- 2 Tbps
- Management
- Console, RJ-45, USB, Ethernet
- Throughput
- BGP up to 360 Mpps
- Operating Temp
- 32 to 104°F
Potential Threats
25 Known CVEs
Default IP
192.168.1.1
Default admin panel address for Cisco Cisco Catalyst 9500-24Y4C
Known CVE Vulnerabilities (25)
A vulnerability in the Switch Integrated Security Features (SISF) of Cisco IOS Software, Cisco IOS XE Software, Cisco NX-OS Software, and Cisco Wirele...
A vulnerability in the lobby ambassador web interface of Cisco IOS XE Wireless Controller Software could allow an authenticated, remote attacker to re...
A vulnerability in the Cisco Express Forwarding functionality of Cisco IOS XE Software for Cisco ASR 903 Aggregation Services Routers with Route Switc...
A vulnerability in the Out-of-Band Access Point (AP) Image Download, the Clean Air Spectral Recording, and the client debug bundles features of Cisco...
A vulnerability in the health monitoring diagnostics of Cisco Nexus 3000 Series Switches and Cisco Nexus 9000 Series Switches in standalone NX-OS mode...
A vulnerability in the SIP processing subsystem of Cisco BroadWorks could allow an unauthenticated, remote attacker to halt the processing of incoming...
A vulnerability in the access control list (ACL) programming of Cisco Nexus 3550-F Switches could allow an unauthenticated, remote attacker to send tr...
A vulnerability in the AnyConnect firewall for Cisco Adaptive Security Appliance (ASA) Software and Cisco Firepower Threat Defense (FTD) Software coul...
A vulnerability in the upload module of Cisco RV340 and RV345 Dual WAN Gigabit VPN Routers could allow an authenticated, remote attacker to execute ar...
A vulnerability in the web-based management interface of Cisco Identity Services Engine (ISE) could allow an authenticated, remote attacker to upload...
Showing 10 of 25
FAQ
The most common default credentials for Cisco Cisco Catalyst 9500-24Y4C are listed in the table above. Always change these immediately after setup.
The default username for Cisco Cisco Catalyst 9500-24Y4C is typically "admin". The full list of default credentials including username, password, access type and port is shown in the table on this page.
Log in to the admin panel using the default credentials listed above. Navigate to Administration → Password or System → Account settings. Enter the current password and set a new strong password. Save the changes.
Locate the Reset button (usually a small pinhole on the back/bottom of the device). Hold it for 10-30 seconds while powered on until the LEDs flash. The device will reboot with default settings.
No. Default credentials are publicly known and frequently exploited by automated scanners. Change the admin password immediately after first login.
Cisco Cisco Catalyst 9500-24Y4C has 25 known CVE vulnerabilities documented in our database. The full list with severity ratings is shown on this page. Apply the latest firmware update from the manufacturer to address known issues.
