Cisco Cisco Catalyst 9300-48T
- The Cisco Catalyst 9300-48T is a high-performance, scalable, and secure Layer 3 switch designed for campus networks.
Specifications
- OS
- Cisco IOS XE
- CPU
- x86
- PoE
- No
- QoS
- Yes
- RAM
- 8 GB
- USB
- Yes
- Flash
- 16 GB
- Layer
- Layer 3
- Ports
- 48x 10/100/1000 Ethernet
- VLANs
- Yes
- Uplinks
- Network Module uplinks
- LAN Ports
- 48x GE
- Max VLANs
- 4094
- Switching Capacity
- 176 Gbps
- Management
- Console, USB, Ethernet, Cisco DNA Center
- Throughput
- 130.95 Mpps
- Operating Temp
- 32 to 113°F (0 to 45°C)
Potential Threats
16 Known CVEs
Default IP
192.168.1.123
Default admin panel address for Cisco Cisco Catalyst 9300-48T
Known CVE Vulnerabilities (16)
A vulnerability in the Cisco Express Forwarding functionality of Cisco IOS XE Software for Cisco ASR 903 Aggregation Services Routers with Route Switc...
A vulnerability in the Out-of-Band Access Point (AP) Image Download, the Clean Air Spectral Recording, and the client debug bundles features of Cisco...
A vulnerability in confederation implementation for the Border Gateway Protocol (BGP) in Cisco IOS XR Software could allow an unauthenticated, re...
A vulnerability in the SNMP subsystem of Cisco IOS Software and Cisco IOS XE Software could allow an authenticated, remote attacker to cause a DoS con...
A vulnerability in the REST API of Cisco Meeting Management could allow a remote, authenticated attacker with low privileges to elevate privileges to...
A vulnerability in the web-based management interface of Cisco Firepower Management Center (FMC) Software could allow an unauthenticated, remote attac...
A vulnerability in the session authentication functionality of the Remote Access SSL VPN feature of Cisco Adaptive Security Appliance (ASA) Software a...
A vulnerability in the SSH subsystem of Cisco Adaptive Security Appliance (ASA) Software could allow an authenticated, remote attacker to execute oper...
A vulnerability in the VPN and management web servers of the Cisco Adaptive Security Virtual Appliance (ASAv) and Cisco Secure Firewall Threat Defense...
A vulnerability in the handling of specific Ethernet frames by Cisco IOS XR Software for various Cisco Network Convergence System (NCS) platforms coul...
Showing 10 of 16
FAQ
The most common default credentials for Cisco Cisco Catalyst 9300-48T are listed in the table above. Always change these immediately after setup.
The default username for Cisco Cisco Catalyst 9300-48T is typically "admin". The full list of default credentials including username, password, access type and port is shown in the table on this page.
Log in to the admin panel using the default credentials listed above. Navigate to Administration → Password or System → Account settings. Enter the current password and set a new strong password. Save the changes.
Locate the Reset button (usually a small pinhole on the back/bottom of the device). Hold it for 10-30 seconds while powered on until the LEDs flash. The device will reboot with default settings.
No. Default credentials are publicly known and frequently exploited by automated scanners. Change the admin password immediately after first login.
Cisco Cisco Catalyst 9300-48T has 16 known CVE vulnerabilities documented in our database. The full list with severity ratings is shown on this page. Apply the latest firmware update from the manufacturer to address known issues.
