Cisco Cisco Catalyst 9300-48P
- The Cisco Catalyst 9300-48P is a high-performance, scalable, and secure Layer 2 and Layer 3 switch designed for campus networks.
Specifications
- OS
- Cisco IOS XE
- PoE
- PoE+
- RAM
- 8 GB
- USB
- 1x USB 2.0
- Flash
- 16 GB
- Layer
- Layer 3
- Uplinks
- Network module slot
- Stacking
- StackWise-480
- LAN Ports
- 48x 10/100/1000
- PoE Ports
- 48
- Switching Capacity
- 176 Gbps
- Management
- Console, USB, Ethernet
- PoE Budget
- 740 W
- Throughput
- 130.95 Mpps
- Operating Temp
- 32 to 113 F
Potential Threats
14 Known CVEs
Default IP
192.168.1.123
Default admin panel address for Cisco Cisco Catalyst 9300-48P
Known CVE Vulnerabilities (14)
A vulnerability in the backup feature of Cisco UCS Central Software could allow an attacker with access to a backup file to learn sensitive informatio...
A vulnerability in the handling of specific Ethernet frames by Cisco IOS XR Software for various Cisco Network Convergence System (NCS) platforms coul...
A vulnerability in Cisco Smart Licensing Utility could allow an unauthenticated, remote attacker to access sensitive information. This vulnerabilit...
A vulnerability in Cisco Smart Licensing Utility (CSLU) could allow an unauthenticated, remote attacker to log into an affected system by using a stat...
A vulnerability in the CLI of Cisco NX-OS Software could allow an authenticated user in possession of Administrator credentials to execute arbitrary c...
A vulnerability in the OSPF version 2 (OSPFv2) feature of Cisco IOS XE Software could allow an unauthenticated, adjacent attacker to cause an affected...
A vulnerability in the CLI of the Cisco Integrated Management Controller (IMC) could allow an authenticated, local attacker to perform command injecti...
A vulnerability in the IPv4 Software-Defined Access (SD-Access) fabric edge node feature of Cisco IOS XE Software could allow an unauthenticated, remo...
A vulnerability in the NETCONF feature of Cisco IOS XE Software could allow an authenticated, remote attacker to elevate privileges to root on an affe...
A vulnerability in Cisco IOS Software for Cisco Catalyst 6000 Series Switches could allow an unauthenticated, adjacent attacker to cause an affected d...
Showing 10 of 14
FAQ
The most common default credentials for Cisco Cisco Catalyst 9300-48P are listed in the table above. Always change these immediately after setup.
The default username for Cisco Cisco Catalyst 9300-48P is typically "admin". The full list of default credentials including username, password, access type and port is shown in the table on this page.
Log in to the admin panel using the default credentials listed above. Navigate to Administration → Password or System → Account settings. Enter the current password and set a new strong password. Save the changes.
Locate the Reset button (usually a small pinhole on the back/bottom of the device). Hold it for 10-30 seconds while powered on until the LEDs flash. The device will reboot with default settings.
No. Default credentials are publicly known and frequently exploited by automated scanners. Change the admin password immediately after first login.
Cisco Cisco Catalyst 9300-48P has 14 known CVE vulnerabilities documented in our database. The full list with severity ratings is shown on this page. Apply the latest firmware update from the manufacturer to address known issues.
