Cisco Cisco Catalyst 9200L-48P-4G
- The Cisco Catalyst 9200L-48P-4G is a Layer 3, 1GbE, and PoE+ switch designed for enterprise networks.
Specifications
- OS
- Cisco IOS XE
- PoE
- PoE+
- USB
- 1x USB 2.0
- Layer
- Layer 3
- VLANs
- 4094
- Uplinks
- 4x 1G SFP
- LAN Ports
- 48x 10/100/1000
- Max VLANs
- 4094
- PoE Ports
- 48
- Switching Capacity
- 104 Gbps
- Management
- RJ-45 console, USB-C console, USB-A
- PoE Budget
- 740 W
- Throughput
- 154.76 Mpps
- Operating Temp
- -5 to 45 C
Potential Threats
25 Known CVEs
Default IP
192.168.154.100
Default admin panel address for Cisco Cisco Catalyst 9200L-48P-4G
Known CVE Vulnerabilities (25)
Rejected reason: This CVE ID has been rejected or withdrawn by its CVE Numbering Authority because it is Unused
Improper Isolation or Compartmentalization in the stream cache mechanism for some Intel(R) Processors may allow an authenticated user to potentially e...
A vulnerability in the API of Cisco Unified Intelligence Center could allow an authenticated, remote attacker to perform a horizontal privilege escala...
A vulnerability in Cisco Unified Intelligence Center could allow an authenticated, remote attacker to elevate privileges to Administrator for a limite...
A vulnerability in multiple Cisco Unified Communications and Contact Center Solutions products could allow an authenticated, local attacker to elevate...
A vulnerability in the Wireless Network Control daemon (wncd) of Cisco IOS XE Software for Wireless LAN Controllers (WLCs) could allow an unauthentica...
A vulnerability in the handling of specific packets that are punted from a line card to a route processor in Cisco IOS XR Software Release 7.9.2 could...
A vulnerability in confederation implementation for the Border Gateway Protocol (BGP) in Cisco IOS XR Software could allow an unauthenticated, re...
A vulnerability in the CLI of Cisco APIC could allow an authenticated, local attacker to execute arbitrary commands as root on the underlying ope...
A vulnerability in the web UI of Cisco APIC could allow an authenticated, remote attacker to perform a stored XSS attack on an affected system. To exp...
Showing 10 of 25
FAQ
The most common default credentials for Cisco Cisco Catalyst 9200L-48P-4G are listed in the table above. Always change these immediately after setup.
The default username for Cisco Cisco Catalyst 9200L-48P-4G is typically "admin". The full list of default credentials including username, password, access type and port is shown in the table on this page.
Log in to the admin panel using the default credentials listed above. Navigate to Administration → Password or System → Account settings. Enter the current password and set a new strong password. Save the changes.
Locate the Reset button (usually a small pinhole on the back/bottom of the device). Hold it for 10-30 seconds while powered on until the LEDs flash. The device will reboot with default settings.
No. Default credentials are publicly known and frequently exploited by automated scanners. Change the admin password immediately after first login.
Cisco Cisco Catalyst 9200L-48P-4G has 25 known CVE vulnerabilities documented in our database. The full list with severity ratings is shown on this page. Apply the latest firmware update from the manufacturer to address known issues.
