Cisco Cisco Catalyst 2960XR-48TS-I
- The Cisco Catalyst 2960XR-48TS-I is a high-performance, fixed-configuration switch that provides reliable and secure connectivity for small to medium-sized businesses.
Specifications
- OS
- Cisco IOS
- PoE
- No
- QoS
- Yes
- USB
- Yes
- Layer
- L2
- VLANs
- 4094
- Uplinks
- 4x 1G SFP
- Auto MDI/X
- Yes
- LAN Ports
- 48x Fast Ethernet
- Max VLANs
- 1023
- Switching Capacity
- 216 Gbps
- Management
- CLI, SNMP, Web
- Throughput
- 107.1 Mpps
- Operating Temp
- -5 to 45 C
Potential Threats
22 Known CVEs
Default IP
192.168.0.1
Default admin panel address for Cisco Cisco Catalyst 2960XR-48TS-I
Known CVE Vulnerabilities (22)
A vulnerability in the health monitoring diagnostics of Cisco Nexus 3000 Series Switches and Cisco Nexus 9000 Series Switches in standalone NX-OS mode...
A vulnerability in the SNMP subsystem of Cisco IOS Software and Cisco IOS XE Software could allow an authenticated, remote attacker to cause a DoS con...
A vulnerability in the logging component of Cisco Unified Communications Manager IM & Presence Service (Unified CM IM&P) could allow an authen...
A vulnerability in the web UI of Cisco Desk Phone 9800 Series, Cisco IP Phone 7800 and 8800 Series, and Cisco Video Phone 8875 could allow an unauthen...
A vulnerability in the web-based management interface of Cisco ATA 190 Series Analog Telephone Adapter firmware could allow an unauthenticated, remote...
A vulnerability in the web-based management interface of Cisco ATA 190 Multiplatform Series Analog Telephone Adapter firmware could allow an authentic...
A vulnerability in the web-based management interface of Cisco ATA 190 Series Analog Telephone Adapter firmware could allow an unauthenticated, remote...
A vulnerability in Cisco Nexus Dashboard Fabric Controller (NDFC) could allow an authenticated, remote attacker with low privileges to execute arbitra...
A vulnerability in the Cisco Nexus Dashboard Fabric Controller (NDFC) software, formerly Cisco Data Center Network Manager (DCNM), could allow an atta...
A vulnerability in Cisco Nexus Dashboard Fabric Controller (NDFC), formerly Cisco Data Center Network Manager (DCNM), could allow an authenticated, re...
Showing 10 of 22
FAQ
The most common default credentials for Cisco Cisco Catalyst 2960XR-48TS-I are listed in the table above. Always change these immediately after setup.
The default username for Cisco Cisco Catalyst 2960XR-48TS-I is typically "admin". The full list of default credentials including username, password, access type and port is shown in the table on this page.
Log in to the admin panel using the default credentials listed above. Navigate to Administration → Password or System → Account settings. Enter the current password and set a new strong password. Save the changes.
Locate the Reset button (usually a small pinhole on the back/bottom of the device). Hold it for 10-30 seconds while powered on until the LEDs flash. The device will reboot with default settings.
No. Default credentials are publicly known and frequently exploited by automated scanners. Change the admin password immediately after first login.
Cisco Cisco Catalyst 2960XR-48TS-I has 22 known CVE vulnerabilities documented in our database. The full list with severity ratings is shown on this page. Apply the latest firmware update from the manufacturer to address known issues.
