Cisco Cisco Catalyst 2960X-48TS-L
- The Cisco Catalyst 2960X-48TS-L is a high-performance, Layer 3 switch that provides advanced security and network services.
Specifications
- OS
- Cisco IOS
- LAN
- 10/100/1000 Ethernet
- PoE
- No
- QoS
- Yes
- RAM
- 256 MB
- USB
- 1x USB Type-A
- Flash
- 128 MB
- Layer
- Layer 2
- Ports
- 48x RJ-45
- VLANs
- 1023
- Uplinks
- 4x 1G SFP
- Auto MDI/X
- Yes
- LAN Ports
- 48
- Max VLANs
- 1023
- Switching Capacity
- 216 Gbps
- Management
- Managed
Potential Threats
17 Known CVEs
Default IP
192.168.0.1
Default admin panel address for Cisco Cisco Catalyst 2960X-48TS-L
Known CVE Vulnerabilities (17)
A vulnerability in Cisco Smart Licensing Utility (CSLU) could allow an unauthenticated, remote attacker to log into an affected system by using a stat...
A vulnerability in the restricted security domain implementation of Cisco Application Policy Infrastructure Controller (APIC) could allow an authentic...
A vulnerability in the CLI of Cisco NX-OS Software could allow an authenticated user in possession of Administrator credentials to execute arbitrary c...
A vulnerability in the Object Groups for Access Control Lists (ACLs) feature of Cisco Firepower Management Center (FMC) Software could allow an unauth...
A vulnerability in the web-based management interface of Cisco AsyncOS Software for Cisco Secure Email and Web Manager and Secure Email Gateway could...
A vulnerability in the CLI of the Cisco Integrated Management Controller (IMC) could allow an authenticated, local attacker to perform command injecti...
A vulnerability in the IPv4 Software-Defined Access (SD-Access) fabric edge node feature of Cisco IOS XE Software could allow an unauthenticated, remo...
A vulnerability in the multicast DNS (mDNS) gateway feature of Cisco IOS XE Software for Wireless LAN Controllers (WLCs) could allow an unauthenticate...
A vulnerability in the boot process of Cisco Access Point (AP) Software could allow an unauthenticated, physical attacker to bypass the Cisco Secure B...
A vulnerability in the ISE Posture (System Scan) module of Cisco Secure Client for Linux could allow an authenticated, local attacker to elevate privi...
Showing 10 of 17
FAQ
The most common default credentials for Cisco Cisco Catalyst 2960X-48TS-L are listed in the table above. Always change these immediately after setup.
The default username for Cisco Cisco Catalyst 2960X-48TS-L is typically "admin". The full list of default credentials including username, password, access type and port is shown in the table on this page.
Log in to the admin panel using the default credentials listed above. Navigate to Administration → Password or System → Account settings. Enter the current password and set a new strong password. Save the changes.
Locate the Reset button (usually a small pinhole on the back/bottom of the device). Hold it for 10-30 seconds while powered on until the LEDs flash. The device will reboot with default settings.
No. Default credentials are publicly known and frequently exploited by automated scanners. Change the admin password immediately after first login.
Cisco Cisco Catalyst 2960X-48TS-L has 17 known CVE vulnerabilities documented in our database. The full list with severity ratings is shown on this page. Apply the latest firmware update from the manufacturer to address known issues.
