Ubiquiti Ubiquiti UniFi USW-48
- The Ubiquiti UniFi USW-48 is a high-performance, managed switch designed for enterprise and small-to-medium business networks.
Specifications
- PoE
- No
- Layer
- Layer 2
- Ports
- 48x RJ45
- PoE Out
- No
- Uplinks
- 2x 1G SFP
- LAN Ports
- 48x GE
- Switching Capacity
- 104 Gbps
- Controller
- UniFi Network
- Management
- Ethernet In-Band
- PoE Budget
- 0 W
- Throughput
- 77.376 Mpps
Potential Threats
Default IP
192.168.1.1
Default admin panel address for Ubiquiti Ubiquiti UniFi USW-48
FAQ
The most common default credentials for Ubiquiti Ubiquiti UniFi USW-48 are listed in the table above. Always change these immediately after setup.
The default username for Ubiquiti Ubiquiti UniFi USW-48 is typically "admin". The full list of default credentials including username, password, access type and port is shown in the table on this page.
Log in to the admin panel using the default credentials listed above. Navigate to Administration → Password or System → Account settings. Enter the current password and set a new strong password. Save the changes.
Locate the Reset button (usually a small pinhole on the back/bottom of the device). Hold it for 10-30 seconds while powered on until the LEDs flash. The device will reboot with default settings.
No. Default credentials are publicly known and frequently exploited by automated scanners. Change the admin password immediately after first login.
No CVE vulnerabilities have been linked to Ubiquiti Ubiquiti UniFi USW-48 in our database. This may mean the device has a good security record, or that vulnerabilities exist but have not been officially assigned CVE identifiers.
