Ubiquiti Ubiquiti UniFi US-8-150W
- The Ubiquiti UniFi US-8-150W is a managed Gigabit switch with 8 ports and 150W of PoE+ power.
Specifications
- PoE
- 802.3af/at Passive 24V
- QoS
- Yes
- Layer
- Layer 2
- Ports
- 8x GE RJ45, 2x SFP
- VLANs
- Yes
- PoE Out
- 130 W
- Uplinks
- 2x SFP
- Auto MDI/X
- Yes
- PoE Ports
- 8x PoE
- Switching Capacity
- 20 Gbps
- Controller
- UniFi Network
- Management
- Ethernet In-Band
- PoE Budget
- 150 W
- Operating Temp
- -5 to 45°C
Potential Threats
Default IP
192.168.1.1
Default admin panel address for Ubiquiti Ubiquiti UniFi US-8-150W
FAQ
The most common default credentials for Ubiquiti Ubiquiti UniFi US-8-150W are listed in the table above. Always change these immediately after setup.
The default username for Ubiquiti Ubiquiti UniFi US-8-150W is typically "admin". The full list of default credentials including username, password, access type and port is shown in the table on this page.
Log in to the admin panel using the default credentials listed above. Navigate to Administration → Password or System → Account settings. Enter the current password and set a new strong password. Save the changes.
Locate the Reset button (usually a small pinhole on the back/bottom of the device). Hold it for 10-30 seconds while powered on until the LEDs flash. The device will reboot with default settings.
No. Default credentials are publicly known and frequently exploited by automated scanners. Change the admin password immediately after first login.
No CVE vulnerabilities have been linked to Ubiquiti Ubiquiti UniFi US-8-150W in our database. This may mean the device has a good security record, or that vulnerabilities exist but have not been officially assigned CVE identifiers.
