TP-Link TP-Link TL-SG3428X
- The TP-Link TL-SG3428X is a Gigabit L2 managed switch that provides 26 Gigabit RJ45 ports and 4 SFP+ slots.
Specifications
- LAN
- 24x 10/100/1000 RJ45
- QoS
- Yes
- Layer
- L2+/L3 Static
- Ports
- 24x GE RJ45, 4x 10G SFP+
- VLANs
- Yes
- Uplinks
- 4x 10G SFP+
- Auto MDI/X
- Yes
- LAN Ports
- 24
- Max VLANs
- 4094
- Switching Capacity
- 128 Gbps
- Management
- Web, CLI, SNMP, Omada SDN
- Operating Temp
- 0°C to 50°C
Potential Threats
Default IP
192.168.0.1
Default admin panel address for TP-Link TP-Link TL-SG3428X
Default Credentials — TP-Link TP-Link TL-SG3428X
FAQ
The most common default credentials for TP-Link TP-Link TL-SG3428X are listed in the table above. Always change these immediately after setup.
The default username for TP-Link TP-Link TL-SG3428X is typically "admin". The full list of default credentials including username, password, access type and port is shown in the table on this page.
Log in to the admin panel using the default credentials listed above. Navigate to Administration → Password or System → Account settings. Enter the current password and set a new strong password. Save the changes.
Locate the Reset button (usually a small pinhole on the back/bottom of the device). Hold it for 10-30 seconds while powered on until the LEDs flash. The device will reboot with default settings.
No. Default credentials are publicly known and frequently exploited by automated scanners. Change the admin password immediately after first login.
No CVE vulnerabilities have been linked to TP-Link TP-Link TL-SG3428X in our database. This may mean the device has a good security record, or that vulnerabilities exist but have not been officially assigned CVE identifiers.
