MikroTik MikroTik RB2011UAS-2HnD-IN
- The MikroTik RB2011UAS-2HnD-IN is a compact and versatile router that provides wireless and wired connectivity options.
Specifications
- OS
- RouterOS
- CPU
- 600 MHz
- LAN
- Fast/Gigabit Ethernet
- PoE
- Passive PoE in
- QoS
- Yes
- RAM
- 128 MB
- USB
- 1x USB 2.0
- VPN
- Yes
- Wi-Fi
- 802.11b/g/n
- Bands
- 2.4 GHz
- Flash
- 128 MB
- Ports
- 10x RJ45, 1x SFP, 1x USB 2.0
- Radios
- 1
- Antenna
- 2x 4 dBi
- PoE Out
- Passive PoE out
- Firewall
- Yes
- LAN Ports
- 10
- PoE Ports
- 1
- Switching Capacity
- Yes
- WAN Ports
- 1
- Management
- Web/CLI/WinBox
- Operating Temp
- -35 to 65 C
Potential Threats
1 Known CVEs
Default IP
192.168.88.1
Default admin panel address for MikroTik MikroTik RB2011UAS-2HnD-IN
Default Credentials — MikroTik MikroTik RB2011UAS-2HnD-IN
Known CVE Vulnerabilities (1)
FAQ
The most common default credentials for MikroTik MikroTik RB2011UAS-2HnD-IN are listed in the table above. Always change these immediately after setup.
The default username for MikroTik MikroTik RB2011UAS-2HnD-IN is typically "admin". The full list of default credentials including username, password, access type and port is shown in the table on this page.
Log in to the admin panel using the default credentials listed above. Navigate to Administration → Password or System → Account settings. Enter the current password and set a new strong password. Save the changes.
Locate the Reset button (usually a small pinhole on the back/bottom of the device). Hold it for 10-30 seconds while powered on until the LEDs flash. The device will reboot with default settings.
No. Default credentials are publicly known and frequently exploited by automated scanners. Change the admin password immediately after first login.
The default admin login address for MikroTik MikroTik RB2011UAS-2HnD-IN is shown in the "Default IP" field above. Most routers use 192.168.1.1 or 192.168.0.1. Open a browser on a device connected to the router and navigate to that IP.
Log in to the router admin panel at the default IP address. Go to Wireless or Wi-Fi settings. Find the WPA2/WPA3 passphrase field and update it. Save and reconnect your devices.
Change the default admin password and Wi-Fi password immediately. Disable WPS (Wi-Fi Protected Setup) — it is vulnerable to brute-force attacks. Enable WPA3 encryption if supported. Turn off remote management unless needed. Keep firmware updated.
MikroTik MikroTik RB2011UAS-2HnD-IN has 1 known CVE vulnerabilities documented in our database. The full list with severity ratings is shown on this page. Apply the latest firmware update from the manufacturer to address known issues.
