MikroTik hEX S
RB760iGS - MikroTik hEX S 5-port Gigabit router with SFP and PoE-out.
Specifications
- OS
- RouterOS / SwitchOS
- CPU
- MT7621A 880MHz dual-core
- LAN
- 5x Gigabit Ethernet
- PoE
- PoE in
- RAM
- 256 MB
- USB
- 1x USB 2.0
- WAN
- 1x Gigabit Ethernet
- Flash
- 16 MB
- Ports
- 5x Gigabit + 1x SFP
- PoE Out
- Port 5
- Storage
- microSD
- LAN Ports
- 5
- PoE Ports
- 1
- WAN Ports
- 1
Potential Threats
2 Known CVEs
Default IP
192.168.88.1
Default admin panel address for MikroTik hEX S
Default Credentials — MikroTik hEX S
Known CVE Vulnerabilities (2)
The SSH daemon on MikroTik routers through v6.44.3 could allow remote attackers to generate CPU activity, trigger refusal of new authorized connection...
A vulnerability in the FTP daemon on MikroTik routers through 6.44.3 could allow remote attackers to exhaust all available memory, causing the device...
FAQ
The most common default credentials for MikroTik hEX S are listed in the table above. Always change these immediately after setup.
The default username for MikroTik hEX S is typically "admin". The full list of default credentials including username, password, access type and port is shown in the table on this page.
Log in to the admin panel using the default credentials listed above. Navigate to Administration → Password or System → Account settings. Enter the current password and set a new strong password. Save the changes.
Locate the Reset button (usually a small pinhole on the back/bottom of the device). Hold it for 10-30 seconds while powered on until the LEDs flash. The device will reboot with default settings.
No. Default credentials are publicly known and frequently exploited by automated scanners. Change the admin password immediately after first login.
The default admin login address for MikroTik hEX S is shown in the "Default IP" field above. Most routers use 192.168.1.1 or 192.168.0.1. Open a browser on a device connected to the router and navigate to that IP.
Log in to the router admin panel at the default IP address. Go to Wireless or Wi-Fi settings. Find the WPA2/WPA3 passphrase field and update it. Save and reconnect your devices.
Change the default admin password and Wi-Fi password immediately. Disable WPS (Wi-Fi Protected Setup) — it is vulnerable to brute-force attacks. Enable WPA3 encryption if supported. Turn off remote management unless needed. Keep firmware updated.
MikroTik hEX S has 2 known CVE vulnerabilities documented in our database. The full list with severity ratings is shown on this page. Apply the latest firmware update from the manufacturer to address known issues.
