Juniper Networks Juniper QFX5200-48Y
- The Juniper QFX5200-48Y is a high-performance, 10GbE and 40GbE switch designed for data center and campus networks.
Specifications
- OS
- Junos OS
- QoS
- Yes
- USB
- 1x USB
- Layer
- Layer 2/3
- Ports
- 48x 25GbE SFP28, 8x 100GbE QSFP28
- VLANs
- 4094
- Uplinks
- 8x 100GbE QSFP28
- LAN Ports
- 48
- Max VLANs
- 4094
- Switching Capacity
- 4 Tbps
- Management
- CLI, Web, SNMP, Junos Space
- Throughput
- 2.97 Bpps
- Operating Temp
- 0 to 40 C
Potential Threats
Default IP
192.168.1.1
Default admin panel address for Juniper Networks Juniper QFX5200-48Y
Default Credentials — Juniper Networks Juniper QFX5200-48Y
| Username | Password | Access Type | Protocol | Port | Notes |
|---|---|---|---|---|---|
| (blank) | console | Console | — |
FAQ
The most common default credentials for Juniper Networks Juniper QFX5200-48Y are listed in the table above. Always change these immediately after setup.
The default username for Juniper Networks Juniper QFX5200-48Y is typically "admin". The full list of default credentials including username, password, access type and port is shown in the table on this page.
Log in to the admin panel using the default credentials listed above. Navigate to Administration → Password or System → Account settings. Enter the current password and set a new strong password. Save the changes.
Locate the Reset button (usually a small pinhole on the back/bottom of the device). Hold it for 10-30 seconds while powered on until the LEDs flash. The device will reboot with default settings.
No. Default credentials are publicly known and frequently exploited by automated scanners. Change the admin password immediately after first login.
No CVE vulnerabilities have been linked to Juniper Networks Juniper QFX5200-48Y in our database. This may mean the device has a good security record, or that vulnerabilities exist but have not been officially assigned CVE identifiers.
