Juniper Networks Juniper EX9214
- The Juniper Networks Juniper EX9214 is a high-performance, 10GbE Ethernet switch designed for data center and campus networks.
Specifications
- OS
- Junos OS
- LAN
- Ethernet
- USB
- Yes
- WAN
- Modular
- DIN Rail
- 19-inch rack
- Layer
- Layer 2/3
- Ports
- Modular
- VLANs
- 4096
- Uplinks
- Modular 10/40/100GbE
- Max VLANs
- 4096
- Switching Capacity
- Up to 13.2 Tbps
- Management
- Junos OS
- Throughput
- Up to 7.8 Bpps
Potential Threats
Default IP
192.168.1.1
Default admin panel address for Juniper Networks Juniper EX9214
FAQ
The most common default credentials for Juniper Networks Juniper EX9214 are listed in the table above. Always change these immediately after setup.
The default username for Juniper Networks Juniper EX9214 is typically "admin". The full list of default credentials including username, password, access type and port is shown in the table on this page.
Log in to the admin panel using the default credentials listed above. Navigate to Administration → Password or System → Account settings. Enter the current password and set a new strong password. Save the changes.
Locate the Reset button (usually a small pinhole on the back/bottom of the device). Hold it for 10-30 seconds while powered on until the LEDs flash. The device will reboot with default settings.
No. Default credentials are publicly known and frequently exploited by automated scanners. Change the admin password immediately after first login.
No CVE vulnerabilities have been linked to Juniper Networks Juniper EX9214 in our database. This may mean the device has a good security record, or that vulnerabilities exist but have not been officially assigned CVE identifiers.
