D-Link D-Link DGS-3130-30TS
- The D-Link DGS-3130-30TS is a 24-port Gigabit switch designed for small to medium-sized businesses and organizations.
Specifications
- QoS
- Yes
- USB
- 1x USB 2.0
- Layer
- L2/L3
- Ports
- 24x GE RJ45, 2x 10G SFP+, 4x combo GE/SFP
- VLANs
- Yes
- Uplinks
- 2x 10G SFP+
- LAN Ports
- 30
- Max VLANs
- 4094
- Switching Capacity
- 128 Gbps
- Management
- Web, CLI, SNMP
Potential Threats
Default IP
10.90.90.90
Default admin panel address for D-Link D-Link DGS-3130-30TS
Default Credentials — D-Link D-Link DGS-3130-30TS
FAQ
The most common default credentials for D-Link D-Link DGS-3130-30TS are listed in the table above. Always change these immediately after setup.
The default username for D-Link D-Link DGS-3130-30TS is typically "admin". The full list of default credentials including username, password, access type and port is shown in the table on this page.
Log in to the admin panel using the default credentials listed above. Navigate to Administration → Password or System → Account settings. Enter the current password and set a new strong password. Save the changes.
Locate the Reset button (usually a small pinhole on the back/bottom of the device). Hold it for 10-30 seconds while powered on until the LEDs flash. The device will reboot with default settings.
No. Default credentials are publicly known and frequently exploited by automated scanners. Change the admin password immediately after first login.
No CVE vulnerabilities have been linked to D-Link D-Link DGS-3130-30TS in our database. This may mean the device has a good security record, or that vulnerabilities exist but have not been officially assigned CVE identifiers.
