D-Link D-Link DGS-1210-20
- The D-Link DGS-1210-20 is a 20-port Gigabit Ethernet switch that provides reliable and high-speed connectivity for small to medium-sized businesses.
Specifications
- QoS
- Yes
- Layer
- L2
- Ports
- 16x 10/100/1000 RJ45, 4x Gigabit SFP
- VLANs
- Yes
- Uplinks
- 4x SFP
- LAN Ports
- 20x GE
- Max VLANs
- 256
- Switching Capacity
- 40 Gbps
- Management
- Web, SNMP, CLI
Potential Threats
Default IP
10.90.90.90
Default admin panel address for D-Link D-Link DGS-1210-20
Default Credentials — D-Link D-Link DGS-1210-20
FAQ
The most common default credentials for D-Link D-Link DGS-1210-20 are listed in the table above. Always change these immediately after setup.
The default username for D-Link D-Link DGS-1210-20 is typically "admin". The full list of default credentials including username, password, access type and port is shown in the table on this page.
Log in to the admin panel using the default credentials listed above. Navigate to Administration → Password or System → Account settings. Enter the current password and set a new strong password. Save the changes.
Locate the Reset button (usually a small pinhole on the back/bottom of the device). Hold it for 10-30 seconds while powered on until the LEDs flash. The device will reboot with default settings.
No. Default credentials are publicly known and frequently exploited by automated scanners. Change the admin password immediately after first login.
No CVE vulnerabilities have been linked to D-Link D-Link DGS-1210-20 in our database. This may mean the device has a good security record, or that vulnerabilities exist but have not been officially assigned CVE identifiers.
