Ubiquiti Ubiquiti UniFi AI Bullet
- The Ubiquiti UniFi AI Bullet is a wireless camera designed for indoor and outdoor surveillance, featuring advanced AI-powered object detection and tracking.
Specifications
- AI
- Yes
- PoE
- 802.3af PoE
- WDR
- Yes
- Lens
- 4.1 mm
- Audio
- Two-way audio
- Ports
- 1x FE
- Storage
- MicroSD
- IP Rating
- IP66
- Controller
- UniFi Protect
- Management
- Ethernet
- Resolution
- 4MP
- Color Night Vision
- Yes
- Compression
- H.264
- Operating Temp
- -20 to 50°C
Potential Threats
Default IP
192.168.1.120
Default admin panel address for Ubiquiti Ubiquiti UniFi AI Bullet
FAQ
The most common default credentials for Ubiquiti Ubiquiti UniFi AI Bullet are listed in the table above. Always change these immediately after setup.
The default username for Ubiquiti Ubiquiti UniFi AI Bullet is typically "admin". The full list of default credentials including username, password, access type and port is shown in the table on this page.
Log in to the admin panel using the default credentials listed above. Navigate to Administration → Password or System → Account settings. Enter the current password and set a new strong password. Save the changes.
Locate the Reset button (usually a small pinhole on the back/bottom of the device). Hold it for 10-30 seconds while powered on until the LEDs flash. The device will reboot with default settings.
No. Default credentials are publicly known and frequently exploited by automated scanners. Change the admin password immediately after first login.
No CVE vulnerabilities have been linked to Ubiquiti Ubiquiti UniFi AI Bullet in our database. This may mean the device has a good security record, or that vulnerabilities exist but have not been officially assigned CVE identifiers.
