Ubiquiti Ubiquiti NanoStation M5
- The Ubiquiti NanoStation M5 is a compact, high-performance airMAX device designed for long-range, point-to-point wireless links.
Specifications
- OS
- airOS
- CPU
- Atheros MIPS 24KC 400 MHz
- LAN
- FE
- PoE
- 24V Passive PoE
- RAM
- 32 MB
- Mode
- AP, Station, WDS
- Wi-Fi
- 802.11a/n
- Bands
- 5 GHz
- Flash
- 8 MB
- Ports
- 1x RJ45
- Range
- 15+ km
- Radios
- 1
- Antenna
- 2x 14 dBi
- Channels
- 802.11a/n
- LAN Ports
- 1x FE
- Management
- Web, SNMP, SSH
- Throughput
- 150+ Mbps
- Operating Temp
- -30 to 80 C
Potential Threats
Default IP
192.168.1.20
Default admin panel address for Ubiquiti Ubiquiti NanoStation M5
Default Credentials — Ubiquiti Ubiquiti NanoStation M5
FAQ
The most common default credentials for Ubiquiti Ubiquiti NanoStation M5 are listed in the table above. Always change these immediately after setup.
The default username for Ubiquiti Ubiquiti NanoStation M5 is typically "admin". The full list of default credentials including username, password, access type and port is shown in the table on this page.
Log in to the admin panel using the default credentials listed above. Navigate to Administration → Password or System → Account settings. Enter the current password and set a new strong password. Save the changes.
Locate the Reset button (usually a small pinhole on the back/bottom of the device). Hold it for 10-30 seconds while powered on until the LEDs flash. The device will reboot with default settings.
No. Default credentials are publicly known and frequently exploited by automated scanners. Change the admin password immediately after first login.
No CVE vulnerabilities have been linked to Ubiquiti Ubiquiti NanoStation M5 in our database. This may mean the device has a good security record, or that vulnerabilities exist but have not been officially assigned CVE identifiers.
