TP-Link Archer C7
AC1750 - TP-Link AC1750 Wireless Dual Band Gigabit Router.
Specifications
- Wi-Fi
- 2.4GHz 450Mbps + 5GHz 1300Mbps
- Ports
- 4x Gigabit LAN + 1x Gigabit WAN + 2x USB
- Antennas
- 3x External 5dBi
Potential Threats
4 Known CVEs
Default IP
192.168.0.1
Default admin panel address for TP-Link Archer C7
Default Credentials — TP-Link Archer C7
| Username | Password | Access Type | Protocol | Port | Notes |
|---|---|---|---|---|---|
| web | HTTP | 80 |
Known CVE Vulnerabilities (4)
The authenticated remote command execution (RCE) vulnerability exists in the Parental Control page on TP-Link Archer C7(EU) V2 and TL-WR841N/ND(MS) V...
Archer C5 firmware all versions and Archer C7 firmware versions prior to 'Archer C7(JP)_V2_230602' allow a network-adjacent authenticated attacker to...
A vulnerability has been found in TP-Link Archer C7v2 v2_en_us_180114 and classified as problematic. Affected by this vulnerability is an unknown func...
A password-disclosure issue in the web interface on certain TP-Link devices allows a remote attacker to get full administrative access to the web pane...
FAQ
The most common default credentials for TP-Link Archer C7 are listed in the table above. Always change these immediately after setup.
The default username for TP-Link Archer C7 is typically "admin". The full list of default credentials including username, password, access type and port is shown in the table on this page.
Log in to the admin panel using the default credentials listed above. Navigate to Administration → Password or System → Account settings. Enter the current password and set a new strong password. Save the changes.
Locate the Reset button (usually a small pinhole on the back/bottom of the device). Hold it for 10-30 seconds while powered on until the LEDs flash. The device will reboot with default settings.
No. Default credentials are publicly known and frequently exploited by automated scanners. Change the admin password immediately after first login.
The default admin login address for TP-Link Archer C7 is shown in the "Default IP" field above. Most routers use 192.168.1.1 or 192.168.0.1. Open a browser on a device connected to the router and navigate to that IP.
Log in to the router admin panel at the default IP address. Go to Wireless or Wi-Fi settings. Find the WPA2/WPA3 passphrase field and update it. Save and reconnect your devices.
Change the default admin password and Wi-Fi password immediately. Disable WPS (Wi-Fi Protected Setup) — it is vulnerable to brute-force attacks. Enable WPA3 encryption if supported. Turn off remote management unless needed. Keep firmware updated.
TP-Link Archer C7 has 4 known CVE vulnerabilities documented in our database. The full list with severity ratings is shown on this page. Apply the latest firmware update from the manufacturer to address known issues.
