QNAP QNAP QSW-2104-2S
- QNAP QSW-2104-2S is a 10GbE managed switch designed for small to medium-sized businesses and home offices, offering advanced features such as VLANs, Spanning Tree Protocol, and Quality of Service.
Specifications
- QoS
- Yes
- Layer
- Layer 2
- Ports
- 4x 2.5GbE RJ45, 2x 10GbE SFP+
- Auto MDI/X
- Yes
- LAN Ports
- 6
- Switching Capacity
- 60 Gbps
- Management
- Unmanaged
- Throughput
- 30 Gbps
- Operating Temp
- 0 to 40°C
Potential Threats
Default IP
192.168.1.2
Default admin panel address for QNAP QNAP QSW-2104-2S
FAQ
The most common default credentials for QNAP QNAP QSW-2104-2S are listed in the table above. Always change these immediately after setup.
The default username for QNAP QNAP QSW-2104-2S is typically "admin". The full list of default credentials including username, password, access type and port is shown in the table on this page.
Log in to the admin panel using the default credentials listed above. Navigate to Administration → Password or System → Account settings. Enter the current password and set a new strong password. Save the changes.
Locate the Reset button (usually a small pinhole on the back/bottom of the device). Hold it for 10-30 seconds while powered on until the LEDs flash. The device will reboot with default settings.
No. Default credentials are publicly known and frequently exploited by automated scanners. Change the admin password immediately after first login.
No CVE vulnerabilities have been linked to QNAP QNAP QSW-2104-2S in our database. This may mean the device has a good security record, or that vulnerabilities exist but have not been officially assigned CVE identifiers.
