Linksys Linksys LGS308
- The Linksys LGS308 is a compact, unmanaged Gigabit switch designed for small to medium-sized networks.
Specifications
- LAN
- 8x GE
- QoS
- Yes
- Layer
- L2
- Ports
- 8x RJ45
- VLANs
- No
- Auto MDI/X
- Yes
- LAN Ports
- 8
- Switching Capacity
- 16 Gbps
- Management
- Unmanaged
Potential Threats
Default IP
192.168.1.254
Default admin panel address for Linksys Linksys LGS308
Default Credentials — Linksys Linksys LGS308
FAQ
The most common default credentials for Linksys Linksys LGS308 are listed in the table above. Always change these immediately after setup.
The default username for Linksys Linksys LGS308 is typically "admin". The full list of default credentials including username, password, access type and port is shown in the table on this page.
Log in to the admin panel using the default credentials listed above. Navigate to Administration → Password or System → Account settings. Enter the current password and set a new strong password. Save the changes.
Locate the Reset button (usually a small pinhole on the back/bottom of the device). Hold it for 10-30 seconds while powered on until the LEDs flash. The device will reboot with default settings.
No. Default credentials are publicly known and frequently exploited by automated scanners. Change the admin password immediately after first login.
No CVE vulnerabilities have been linked to Linksys Linksys LGS308 in our database. This may mean the device has a good security record, or that vulnerabilities exist but have not been officially assigned CVE identifiers.
