HPE HPE FlexNetwork 5510 48G
- The HPE FlexNetwork 5510 48G is a high-performance, low-latency Ethernet switch designed for data center and campus networks.
Specifications
- QoS
- Yes
- USB
- 1x USB
- Layer
- L3
- Ports
- 48x RJ-45, 4x SFP+
- VLANs
- 4094
- Uplinks
- 4x 10GbE SFP+
- LAN Ports
- 48x 10/100/1000
- Max VLANs
- 4094
- Switching Capacity
- 176 Gbps
- Management
- CLI, Web, SNMP
- Throughput
- 130.9 Mpps
Potential Threats
Default IP
192.168.1.254
Default admin panel address for HPE HPE FlexNetwork 5510 48G
Default Credentials — HPE HPE FlexNetwork 5510 48G
| Username | Password | Access Type | Protocol | Port | Notes |
|---|---|---|---|---|---|
| (blank) | console | Console | — |
FAQ
The most common default credentials for HPE HPE FlexNetwork 5510 48G are listed in the table above. Always change these immediately after setup.
The default username for HPE HPE FlexNetwork 5510 48G is typically "admin". The full list of default credentials including username, password, access type and port is shown in the table on this page.
Log in to the admin panel using the default credentials listed above. Navigate to Administration → Password or System → Account settings. Enter the current password and set a new strong password. Save the changes.
Locate the Reset button (usually a small pinhole on the back/bottom of the device). Hold it for 10-30 seconds while powered on until the LEDs flash. The device will reboot with default settings.
No. Default credentials are publicly known and frequently exploited by automated scanners. Change the admin password immediately after first login.
No CVE vulnerabilities have been linked to HPE HPE FlexNetwork 5510 48G in our database. This may mean the device has a good security record, or that vulnerabilities exist but have not been officially assigned CVE identifiers.
