HPE HPE Aruba CX 6200F
- The HPE Aruba CX 6200F is a high-performance, Layer 3 switch designed for campus and data center networks.
Specifications
- OS
- AOS-CX
- LAN
- Gigabit Ethernet
- PoE
- Optional
- QoS
- Yes
- USB
- 1x USB-C console, 1x USB Type-A
- Layer
- L2/L3
- Ports
- 24x/48x 1G
- VLANs
- 4094
- Uplinks
- 4x 1/10G SFP+
- Auto MDI/X
- Yes
- LAN Ports
- 24 or 48
- Max VLANs
- 4094
- Switching Capacity
- 104 Gbps / 176 Gbps
- Management
- ArubaOS-CX
- Throughput
- 77.4 Mpps / 130.9 Mpps
- Operating Temp
- 0 to 45°C
Potential Threats
Default IP
192.168.1.254
Default admin panel address for HPE HPE Aruba CX 6200F
Default Credentials — HPE HPE Aruba CX 6200F
| Username | Password | Access Type | Protocol | Port | Notes |
|---|---|---|---|---|---|
| (blank) | console | Console | — |
FAQ
The most common default credentials for HPE HPE Aruba CX 6200F are listed in the table above. Always change these immediately after setup.
The default username for HPE HPE Aruba CX 6200F is typically "admin". The full list of default credentials including username, password, access type and port is shown in the table on this page.
Log in to the admin panel using the default credentials listed above. Navigate to Administration → Password or System → Account settings. Enter the current password and set a new strong password. Save the changes.
Locate the Reset button (usually a small pinhole on the back/bottom of the device). Hold it for 10-30 seconds while powered on until the LEDs flash. The device will reboot with default settings.
No. Default credentials are publicly known and frequently exploited by automated scanners. Change the admin password immediately after first login.
No CVE vulnerabilities have been linked to HPE HPE Aruba CX 6200F in our database. This may mean the device has a good security record, or that vulnerabilities exist but have not been officially assigned CVE identifiers.
