D-Link D-Link DSL-2750B
- The D-Link DSL-2750B is a wireless router that provides high-speed internet access and supports up to 300 Mbps of wireless speed.
Specifications
- CPU
- Broadcom BCM6328
- DSL
- ADSL2/2+
- LAN
- Fast Ethernet
- QoS
- Yes
- USB
- 1x USB 2.0
- WAN
- DSL
- Mode
- Router
- Wi-Fi
- 802.11b/g/n
- Bands
- 2.4 GHz
- Ports
- 1x RJ11 DSL, 4x RJ45 LAN
- Antenna
- 2x external
- Antennas
- 2
- Firewall
- Yes
- LAN Ports
- 4x FE
- WAN Ports
- 1x RJ11
- Management
- Web UI
Potential Threats
5 Known CVEs
Default IP
192.168.1.1
Default admin panel address for D-Link D-Link DSL-2750B
Default Credentials — D-Link D-Link DSL-2750B
Known CVE Vulnerabilities (5)
Vinoj Cardoza WordPress Poll Plugin v36 and lower executes SQL statement passed in via the pollid POST parameter due to a lack of user input escaping....
Fahad Mahmood RSS Feed Widget Plugin v2.7.9 and lower does not sanitize the value of the "t" GET parameter before echoing it back out inside an input...
Etoile Web Design Ultimate Appointment Booking & Scheduling WordPress Plugin v1.1.9 and lower does not sanitize the value of the "Appointment_ID" GET...
This vulnerability allows network-adjacent attackers to bypass authentication on affected installations of D-Link DIR-867, DIR-878, and DIR-882 router...
This vulnerability allows network-adjacent attackers to bypass authentication on affected installations of D-Link DIR-842 3.13B05 routers. Authenticat...
FAQ
The most common default credentials for D-Link D-Link DSL-2750B are listed in the table above. Always change these immediately after setup.
The default username for D-Link D-Link DSL-2750B is typically "admin". The full list of default credentials including username, password, access type and port is shown in the table on this page.
Log in to the admin panel using the default credentials listed above. Navigate to Administration → Password or System → Account settings. Enter the current password and set a new strong password. Save the changes.
Locate the Reset button (usually a small pinhole on the back/bottom of the device). Hold it for 10-30 seconds while powered on until the LEDs flash. The device will reboot with default settings.
No. Default credentials are publicly known and frequently exploited by automated scanners. Change the admin password immediately after first login.
The default admin login address for D-Link D-Link DSL-2750B is shown in the "Default IP" field above. Most routers use 192.168.1.1 or 192.168.0.1. Open a browser on a device connected to the router and navigate to that IP.
Log in to the router admin panel at the default IP address. Go to Wireless or Wi-Fi settings. Find the WPA2/WPA3 passphrase field and update it. Save and reconnect your devices.
Change the default admin password and Wi-Fi password immediately. Disable WPS (Wi-Fi Protected Setup) — it is vulnerable to brute-force attacks. Enable WPA3 encryption if supported. Turn off remote management unless needed. Keep firmware updated.
D-Link D-Link DSL-2750B has 5 known CVE vulnerabilities documented in our database. The full list with severity ratings is shown on this page. Apply the latest firmware update from the manufacturer to address known issues.
