Cisco Cisco Meraki MR70
- The Cisco Meraki MR70 is a cloud-managed access point designed for high-density environments, offering reliable and secure wireless connectivity.
Specifications
- LAN
- Gigabit Ethernet
- PoE
- 802.3af
- USB
- 1x USB 2.0
- Mode
- Indoor/Outdoor AP
- Wi-Fi
- 802.11ac Wave 2
- Bands
- 2.4 GHz, 5 GHz
- Cloud Management
- Yes
- Ports
- 1x RJ45
- Range
- Long range
- Radios
- 2
- Antenna
- Integrated omni
- Max Clients
- 100+
- MU-MIMO
- Yes
- Antennas
- 2x2:2
- Channels
- 2.4 GHz: 20/40 MHz, 5 GHz: 20/40/80 MHz
- IP Rating
- IP67
- LAN Ports
- 1x GE
- Controller
- Meraki Cloud
- Management
- Cloud
- Operating Temp
- -40 to 65°C
Potential Threats
Default IP
192.168.1.100
Default admin panel address for Cisco Cisco Meraki MR70
FAQ
The most common default credentials for Cisco Cisco Meraki MR70 are listed in the table above. Always change these immediately after setup.
The default username for Cisco Cisco Meraki MR70 is typically "admin". The full list of default credentials including username, password, access type and port is shown in the table on this page.
Log in to the admin panel using the default credentials listed above. Navigate to Administration → Password or System → Account settings. Enter the current password and set a new strong password. Save the changes.
Locate the Reset button (usually a small pinhole on the back/bottom of the device). Hold it for 10-30 seconds while powered on until the LEDs flash. The device will reboot with default settings.
No. Default credentials are publicly known and frequently exploited by automated scanners. Change the admin password immediately after first login.
No CVE vulnerabilities have been linked to Cisco Cisco Meraki MR70 in our database. This may mean the device has a good security record, or that vulnerabilities exist but have not been officially assigned CVE identifiers.
