Cisco Cisco Catalyst 9800-40
- The Cisco Catalyst 9800-40 is a wireless access point designed for high-performance and secure networking.
Specifications
- OS
- Cisco IOS XE
- CPU
- x86 8-core
- QoS
- Yes
- RAM
- 32 GB
- USB
- 1x USB 3.0
- Mode
- Indoor AP controller
- Wi-Fi
- 802.11a/b/g/n/ac/ax
- Bands
- 2.4 GHz, 5 GHz, 6 GHz
- Flash
- 64 GB
- Layer
- Layer 3
- Ports
- 4x 10G SFP+, 2x 1G RJ-45
- Radios
- 6000
- Max Clients
- 2000
- Uplinks
- 4x 10G SFP+
- LAN Ports
- 2x 1G
- Max VLANs
- 4096
- Controller
- Wireless LAN Controller
- Management
- RJ-45 console, USB console, 1x 1G management
- Throughput
- 40 Gbps
- Operating Temp
- 32 to 104°F (0 to 40°C)
Potential Threats
25 Known CVEs
Default IP
192.168.1.1
Default admin panel address for Cisco Cisco Catalyst 9800-40
Known CVE Vulnerabilities (25)
Rejected reason: This CVE ID has been rejected or withdrawn by its CVE Numbering Authority because it is Unused
A vulnerability in Cisco Unified Intelligence Center could allow an authenticated, remote attacker to elevate privileges to Administrator for a limite...
A vulnerability in multiple Cisco Unified Communications and Contact Center Solutions products could allow an authenticated, local attacker to elevate...
A vulnerability in the Out-of-Band Access Point (AP) Image Download, the Clean Air Spectral Recording, and the client debug bundles features of Cisco...
A vulnerability in confederation implementation for the Border Gateway Protocol (BGP) in Cisco IOS XR Software could allow an unauthenticated, re...
A vulnerability in the health monitoring diagnostics of Cisco Nexus 3000 Series Switches and Cisco Nexus 9000 Series Switches in standalone NX-OS mode...
A vulnerability in the bootloader of Cisco NX-OS Software could allow an unauthenticated attacker with physical access to an affected device, or an au...
A vulnerability in the web-based management interface of Cisco Secure Firewall Management Center (FMC) Software, formerly Firepower Management Center...
A vulnerability in the web-based management interface of Cisco Secure Firewall Management Center (FMC) Software, formerly Firepower Management Center...
A vulnerability in the backup feature of Cisco UCS Central Software could allow an attacker with access to a backup file to learn sensitive informatio...
Showing 10 of 25
FAQ
The most common default credentials for Cisco Cisco Catalyst 9800-40 are listed in the table above. Always change these immediately after setup.
The default username for Cisco Cisco Catalyst 9800-40 is typically "admin". The full list of default credentials including username, password, access type and port is shown in the table on this page.
Log in to the admin panel using the default credentials listed above. Navigate to Administration → Password or System → Account settings. Enter the current password and set a new strong password. Save the changes.
Locate the Reset button (usually a small pinhole on the back/bottom of the device). Hold it for 10-30 seconds while powered on until the LEDs flash. The device will reboot with default settings.
No. Default credentials are publicly known and frequently exploited by automated scanners. Change the admin password immediately after first login.
Cisco Cisco Catalyst 9800-40 has 25 known CVE vulnerabilities documented in our database. The full list with severity ratings is shown on this page. Apply the latest firmware update from the manufacturer to address known issues.
