Cisco Cisco ASR 9010
- The Cisco ASR 9010 is a high-performance, scalable router designed for service provider and enterprise networks.
Specifications
- OS
- Cisco IOS XR
- USB
- Yes
- WAN
- Modular
- DIN Rail
- 19-inch rack
- Layer
- L3
- Ports
- Modular
- Management
- Console, RJ-45, USB
- Operating Temp
- 0 to 40 C
Potential Threats
19 Known CVEs
Default IP
192.168.1.1
Default admin panel address for Cisco Cisco ASR 9010
Known CVE Vulnerabilities (19)
In cmdq, there is a possible out of bounds read due to a missing bounds check. This could lead to local information disclosure with System execution p...
In ccu, there is a possible out of bounds write due to a missing bounds check. This could lead to local escalation of privilege with System execution...
In ccu, there is a possible out of bounds write due to a missing bounds check. This could lead to local escalation of privilege with System execution...
A vulnerability in the AnyConnect firewall for Cisco Adaptive Security Appliance (ASA) Software and Cisco Firepower Threat Defense (FTD) Software coul...
A vulnerability in the web-based management interface of Cisco Secure Firewall Management Center (FMC) Software, formerly Firepower Management Center...
A vulnerability in the web-based management interface of Cisco Firepower Management Center (FMC) Software could allow an authenticated, remote attacke...
A vulnerability in the Redfish API of Cisco UCS B-Series, Cisco UCS Managed C-Series, and Cisco UCS X-Series Servers could allow an authenticated, rem...
A vulnerability in the CLI of Cisco NX-OS Software could allow an authenticated, low-privileged, local attacker to execute arbitrary commands on the u...
A vulnerability in the Intermediate System-to-Intermediate System (IS-IS) protocol of Cisco IOS Software and Cisco IOS XE Software could allow an unau...
A vulnerability in the NETCONF feature of Cisco IOS XE Software could allow an authenticated, remote attacker to elevate privileges to root on an affe...
Showing 10 of 19
FAQ
The most common default credentials for Cisco Cisco ASR 9010 are listed in the table above. Always change these immediately after setup.
The default username for Cisco Cisco ASR 9010 is typically "admin". The full list of default credentials including username, password, access type and port is shown in the table on this page.
Log in to the admin panel using the default credentials listed above. Navigate to Administration → Password or System → Account settings. Enter the current password and set a new strong password. Save the changes.
Locate the Reset button (usually a small pinhole on the back/bottom of the device). Hold it for 10-30 seconds while powered on until the LEDs flash. The device will reboot with default settings.
No. Default credentials are publicly known and frequently exploited by automated scanners. Change the admin password immediately after first login.
The default admin login address for Cisco Cisco ASR 9010 is shown in the "Default IP" field above. Most routers use 192.168.1.1 or 192.168.0.1. Open a browser on a device connected to the router and navigate to that IP.
Log in to the router admin panel at the default IP address. Go to Wireless or Wi-Fi settings. Find the WPA2/WPA3 passphrase field and update it. Save and reconnect your devices.
Change the default admin password and Wi-Fi password immediately. Disable WPS (Wi-Fi Protected Setup) — it is vulnerable to brute-force attacks. Enable WPA3 encryption if supported. Turn off remote management unless needed. Keep firmware updated.
Cisco Cisco ASR 9010 has 19 known CVE vulnerabilities documented in our database. The full list with severity ratings is shown on this page. Apply the latest firmware update from the manufacturer to address known issues.
