Check Point Check Point 7080
- The Check Point 7080 is a high-performance, next-generation firewall designed for large-scale enterprise networks.
Specifications
- OS
- Gaia
- Ips
- 2.8 Gbps
- USB
- 2x USB
- VPN
- 4 Gbps
- Rack
- 1U
- Storage
- 1x 320 GB HDD
- Firewall
- Yes
- Sessions
- 12M
- LAN Ports
- 8x GE
- VPN Peers
- 20000
- WAN Ports
- 2x GE
- Management
- Console, Web, CLI
- Throughput
- 18 Gbps
- SSL Inspection
- 1.3 Gbps
Potential Threats
Default IP
192.168.1.1
Default admin panel address for Check Point Check Point 7080
Default Credentials — Check Point Check Point 7080
FAQ
The most common default credentials for Check Point Check Point 7080 are listed in the table above. Always change these immediately after setup.
The default username for Check Point Check Point 7080 is typically "admin". The full list of default credentials including username, password, access type and port is shown in the table on this page.
Log in to the admin panel using the default credentials listed above. Navigate to Administration → Password or System → Account settings. Enter the current password and set a new strong password. Save the changes.
Locate the Reset button (usually a small pinhole on the back/bottom of the device). Hold it for 10-30 seconds while powered on until the LEDs flash. The device will reboot with default settings.
No. Default credentials are publicly known and frequently exploited by automated scanners. Change the admin password immediately after first login.
No CVE vulnerabilities have been linked to Check Point Check Point 7080 in our database. This may mean the device has a good security record, or that vulnerabilities exist but have not been officially assigned CVE identifiers.
