CVE-2026-43292
What is CVE-2026-43292?
In the Linux kernel, the following vulnerability has been resolved: mm/vmalloc: prevent RCU stalls in kasan_release_vmalloc_node When CONFIG_PAGE_OWNER is enabled, freeing KASAN shadow pages during vmalloc cleanup triggers expensive stack unwinding that acquires RCU read locks. Processing a large purge_list without rescheduling can cause the task to hold CPU for extended periods (10+ seconds), leading to RCU stalls and potential OOM conditions. The issue manifests in purge_vmap_node() -> kasan_release_vmalloc_node() where iterating through hundreds or thousands of vmap_area entries and freeing their associated shadow pages causes: rcu: INFO: rcu_preempt detected stalls on CPUs/tasks: rcu: Tasks blocked on level-0 rcu_node (CPUs 0-1): P6229/1:b..l ... task:kworker/0:17 state:R running task stack:28840 pid:6229 ... kasan_release_vmalloc_node+0x1ba/0xad0 mm/vmalloc.c:2299 purge_vmap_node+0x1ba/0xad0 mm/vmalloc.c:2299 Each call to kasan_release_vmalloc() can free many pages, and with page_owner tracking, each free triggers save_stack() which performs stack unwinding under RCU read lock. Without yielding, this creates an unbounded RCU critical section. Add periodic cond_resched() calls within the loop to allow: - RCU grace periods to complete - Other tasks to run - Scheduler to preempt when needed The fix uses need_resched() for immediate response under load, with a batch count of 32 as a guaranteed upper bound to prevent worst-case stalls even under light load.
FAQ
CVE-2026-43292 has a CVSS score of N/A/10, rated as Unknown. Review the affected products list and apply vendor patches.
CVSS (Common Vulnerability Scoring System) rates vulnerability severity from 0.0 to 10.0. CVE-2026-43292 scores N/A/10 (Unknown). Scores 9.0–10.0 are Critical, 7.0–8.9 are High, 4.0–6.9 are Medium, and below 4.0 are Low.
The list of devices confirmed to be affected by CVE-2026-43292 is shown in the "Affected Devices" section above. Check your firmware version against the vendor security advisory and apply the latest patch.
Apply the latest firmware or software update from the vendor. Check the References section above for official advisories and patch notes. If no patch is available, consider disabling the affected feature or isolating the device from untrusted networks.