CVE-2026-43038
What is CVE-2026-43038?
In the Linux kernel, the following vulnerability has been resolved: ipv6: icmp: clear skb2->cb[] in ip6_err_gen_icmpv6_unreach() Sashiko AI-review observed: In ip6_err_gen_icmpv6_unreach(), the skb is an outer IPv4 ICMP error packet where its cb contains an IPv4 inet_skb_parm. When skb is cloned into skb2 and passed to icmp6_send(), it uses IP6CB(skb2). IP6CB interprets the IPv4 inet_skb_parm as an inet6_skb_parm. The cipso offset in inet_skb_parm.opt directly overlaps with dsthao in inet6_skb_parm at offset 18. If an attacker sends a forged ICMPv4 error with a CIPSO IP option, dsthao would be a non-zero offset. Inside icmp6_send(), mip6_addr_swap() is called and uses ipv6_find_tlv(skb, opt->dsthao, IPV6_TLV_HAO). This would scan the inner, attacker-controlled IPv6 packet starting at that offset, potentially returning a fake TLV without checking if the remaining packet length can hold the full 18-byte struct ipv6_destopt_hao. Could mip6_addr_swap() then perform a 16-byte swap that extends past the end of the packet data into skb_shared_info? Should the cb array also be cleared in ip6_err_gen_icmpv6_unreach() and ip6ip6_err() to prevent this? This patch implements the first suggestion. I am not sure if ip6ip6_err() needs to be changed. A separate patch would be better anyway.
FAQ
CVE-2026-43038 has a CVSS score of N/A/10, rated as Unknown. Review the affected products list and apply vendor patches.
CVSS (Common Vulnerability Scoring System) rates vulnerability severity from 0.0 to 10.0. CVE-2026-43038 scores N/A/10 (Unknown). Scores 9.0–10.0 are Critical, 7.0–8.9 are High, 4.0–6.9 are Medium, and below 4.0 are Low.
The list of devices confirmed to be affected by CVE-2026-43038 is shown in the "Affected Devices" section above. Check your firmware version against the vendor security advisory and apply the latest patch.
Apply the latest firmware or software update from the vendor. Check the References section above for official advisories and patch notes. If no patch is available, consider disabling the affected feature or isolating the device from untrusted networks.