CVE-2025-20146
HighWhat is CVE-2025-20146?
A vulnerability in the Layer 3 multicast feature of Cisco IOS XR Software for Cisco ASR 9000 Series Aggregation Services Routers, ASR 9902 Compact High-Performance Routers, and ASR 9903 Compact High-Performance Routers could allow an unauthenticated, remote attacker to cause a line card to reset, resulting in a denial of service (DoS) condition. This vulnerability is due to the incorrect handling of malformed IPv4 multicast packets that are received on line cards where the interface has either an IPv4 access control list (ACL) or a QoS policy applied. An attacker could exploit this vulnerability by sending crafted IPv4 multicast packets through an affected device. A successful exploit could allow the attacker to cause line card exceptions or a hard reset. Traffic over that line card would be lost while the line card reloads.
CVSS Vector Breakdown
CVSS 3.1Exploitable remotely over the network without requiring access to the local system.
No special conditions required. Exploit can be performed reliably and repeatedly.
No authentication required. Any anonymous user can exploit this vulnerability.
No user interaction required. Exploit runs without any victim action.
Exploiting the vulnerability can affect other components beyond the vulnerable one.
No confidentiality impact. Sensitive data is not exposed.
No integrity impact. Data cannot be modified.
Complete denial of service. The component becomes fully unavailable.
Known Affected Devices
FAQ
CVE-2025-20146 has a CVSS score of 8.6/10, rated as High. This is a high severity vulnerability and should be patched as soon as possible.
CVSS (Common Vulnerability Scoring System) rates vulnerability severity from 0.0 to 10.0. CVE-2025-20146 scores 8.6/10 (High). Scores 9.0–10.0 are Critical, 7.0–8.9 are High, 4.0–6.9 are Medium, and below 4.0 are Low.
The list of devices confirmed to be affected by CVE-2025-20146 is shown in the "Affected Devices" section above. Check your firmware version against the vendor security advisory and apply the latest patch.
Apply the latest firmware or software update from the vendor. Check the References section above for official advisories and patch notes. If no patch is available, consider disabling the affected feature or isolating the device from untrusted networks.